For the restoration company:

Within the protocols we use, there should be a very high value on containment because it alone has the ability to prevent further damage to health and property. It keeps a bad situation from getting worse. It puts a lid on it. Everything else addresses the aftermath.

Containment is typically broken into two types: source and area containment.

In talking about source containment, we can use an example of a broken water pipe. With water spewing everywhere, nobody in their right mind would even think about fixing and cleaning up the mess until the water valve was turned off first. That is source containment.

For area containment, think of a quarantine room where someone sick is isolated. The point is not necessarily to keep the person inside, but to keep the pathogens contained and from escaping.

In the first example, the water is quite visible. In the second, the pathogen is microscopic – invisible. This cloak of invisibility is probably the main reason some professionals don’t take containment so seriously. It is the perception that if you can’t see it, it doesn’t exist. 

But it does exist. And in the case of some molds, just a slight breeze or vibration and they go into survival mode – spewing hundreds times more spores into the air. Without proper containment, the cost of the loss can increase dramatically. But the greater cost is in the potential health issues by carelessly allowing cross contamination. 

Reducing the impact of tiny invisible airborne contaminants is exactly why containment is a valuable part of the protocol.

If you will, picture each part of the mold protocol being a person, a specialist in charge of part of the disaster medical team. You would have a first responder (containment), a surgeon (remediation) and a physical therapist (restoration).  Each is tasked with a special function. The first responder stops the bleeding and gets the patient to the surgeon, who cuts away the damaged tissue and does the necessary surgery. The physical therapist gets the body working right again. 

It is not uncommon to hear concern about reduced cleaning revenue due to better containment. Don’t do it ever! Not only is great containment going to endear you to your customer but the insurer and adjuster will appreciate that you prevented displacement which can cost them thousands of dollars. 

As a restoration professional, containing the site should be of utmost concern for you and your employees. A safer work site always benefits the worker and the employer. Think lower workers compensation costs and liability costs.

By effectively reducing the volume of mold spores by the use of source containment, testing is more likely to pass the first time out – reducing the cost of re-cleaning and testing a second time. The same holds true for effective area containment.

While on this subject, the sequence of source containment and then area containment is important. By securing the site rapidly with source containment, you are avoiding mass propagation of mold spores while erecting area containment. There has already been some level of cross contamination prior to your arrival that will be addressed during remediation. Also, do not make the mistake of only source containment, as what’s behind the moldy surface will need to be contained when the wall is opened up. Don’t skip steps in protocol.

At SERVPRO of West Riverside, we are prepared, alert and we will contain the problem as if someone’s life depended on it – as it very well may.